Calibrating the scanner |
|
![[Next]](/file/5442/2DAnimationGuide.iso/Software/Animo v3.1 Demo/manual/next.gif){kind=small}
![[Previous]](/file/5442/2DAnimationGuide.iso/Software/Animo v3.1 Demo/manual/prev.gif){kind=small}
![[Up]](/file/5442/2DAnimationGuide.iso/Software/Animo v3.1 Demo/manual/up.gif){kind=small}
![[Top]](/file/5442/2DAnimationGuide.iso/Software/Animo v3.1 Demo/manual/top.gif){kind=small}
![[Contents]](/file/5442/2DAnimationGuide.iso/Software/Animo v3.1 Demo/manual/content.gif){kind=small}
![[Index]](/file/5442/2DAnimationGuide.iso/Software/Animo v3.1 Demo/manual/index.gif){kind=small}
| |
Errors during calibration
You may get this error box during calibration:
This usually means that part of the calibration chart is not visible to the scanner. You can check how much of the chart the scanner can see by clicking on Preview in the Scanner window. If necessary, move the chart more towards the middle of the scan bed until all of it is visible to the scanner; then click on Calibrate Scan again.
